Wham Bam PI Flexible Build System 220 mm x 220 mm / 8.7” x 8.7”

Wham Bam PI Flexible Build System 220 mm x 220 mm / 8.7” x 8.7”

Fits:  Anet A8, Cocoon 3D Printer Touch, Wanhao Duplicator 6 and Duplicator i3 and i3 Plus, TronXY X2, TronXY P802M, Ultimaker 1, MonoPrice Maker Select Plus and Ultimate and V2, Robo R2

Wham Bam PEX Polymer Build Surface is more temperature resistance, performance, and material stickability than PEI. Simply remove after print - flex slighty to pop print!

The Flexible Build System includes:

- 1 Wham Bam Flexi Magnetic Base - high tempeature resistant up to 150 degrees with high temp 3M adhesive
- 1 Wham Bam Flexi Build Plate - spring steel
- 1 Wham Bam PEX Build Surface Custom Formulated PEX - with high temp 3M adhesive
- 1 Steel Wool 000 - for prepping your PEX Build Surface

Simply installation:

1. Clean your Heated bed and wipe with alcohol.
2. Apply the Wham Bam Magnetic Base to your Heated Bed just by peeling away backing from the pre-mounted adhesive.
3. Apply our Wham Bam PEX Build Surface or your build surface of choice to our Wham Bam Flexi Build Plates by simply cleaning with rubbing alcohol and peeling away protective paper from the pre-mounted adhesive backing.

High quality materials:

Wham Bam Flexi Build Plates are made from high quality spring steel thet won't kink or warp when you flex them, they just return back to shape! The SpringSteel has been formulated with a Chromium Alloy creating a rust proof steel for long life.

Magnets and films have all been formulated to sist over 150 degrees so you can heat your bed to high temps fo specialty filaments and not worry about loss of performance.

Wham Bam PEX Build Surface developed from a specially formulated polymer with a higher melt point than even PEI to attract most any filament without damaging the sheet. Prints easily pop off once cooled and flexed.