ROSA3D-ABS+ Black 1.75mm 1kg

Filament Rosa 3D ABS+ Black 1.75mm 1kg

ABS+ material is a widely used technical plastic with moderate shrinkage (0.4-0.7%).

Great processing properties, such as good flow, bright, vivid colors and very good layer adhesion allow for a wide range of applications of this filament.

ABS+ is characterized by high impact strength, it is impact resistant.

ABS+ from ROSA3D gives an elegant semi-matte finish to the surface of prints. Can be smoothed with acetone.

HOW TO PRINT

• extrusion temperature: 230-270°C
• table temperature: 80-110°C

It is recommended to print in a closed chamber on a heated bed. In case of problems with adhesion, we recommend the use of an adhesive agent. Print cooling is recommended. Its power should be adapted to the capabilities of the printer and the geometry of the printed model.

NOTE: Recommended printing in a well-ventilated room. Do not stay in the room for a long time when printing with an open chamber due to the irritating smell and fumes that may cause dizziness or headaches in sensitive people.

Technical parameters:

• Diameter: 1.75mm
• Diameter tolerance: +/- 0.05
• Ovality tolerance: +/- 0.02
• Weight: 1000g
• Printing temperature: 230-270 °C
• Table temperature: 80-110 °C

Physical parameters:

• Density: 1.05g/cm3
• Smell: irritating
• Tensile elongation: 2.5%
• Tensile strength (until breaking): 44 MPa
• Tensile modulus: 2276 MPa
• Heat distortion temperature: 99